Editing Embedded Programming Tips and Tricks

=Fast Division=
On microcontrollers without a divide instruction very fast division can be done by bit shifting a variable right.<br>
Each shift does a divide by two.<br>

For example<br>
  ''Y = Y >> 1;  (Will result in a divide by 2)<br>''
or<br>
  ''X = X >> 4;  (Will result in a divide by 16)<br>''

By adding a multiplication you can achieve a limited number of other divisions.<br>

For example<br>
  ''Z = Z * 3;<br>''
  ''Z = Z >> 4;  (div 16)<br>''

Will result in a division of 5.33 (16/3 = 5.33)<br>

Be sure to do the multiply first, otherwise bits will be lost.<br>
Also be sure the variable size is large enough to store the multiplied value.<br>

=Repeating Code Using Interrupts=

When writing embedded code you will quite often need to trigger code at a regular interval. (for example flashing an led.<br> 
Over your entire project there maybe many different code segments you wish to execute at different rates.
To do this it can be useful to dedicate one of the microcontrollers hardware timers to perform all these timing tasks.

Since it's bad practice to put lots of code inside an interrupt handler the best approach is to just set flags and then test these flags inside your main program loop.


Such a system might look like this

===AVR===
<pre>

#define off 0
#define on 1

volatile uint16_t clk1000ms=1; // initializing them to 1 insures there is an initial delay cycle when
volatile uint16_t clk100ms=1;  // the code first starts, otherwise they would all happen at
volatile uint8_t clk10ms=1;    // once during first run.

ISR (TIMER0_OVF_vect)
{		
	if (clk1000ms!=off) 
	{
		clk1000ms++;
		if (clk1000ms>=10001) clk1000ms=off;
	}
	if (clk100ms!=off) 
	{
		clk100ms++;
		if (clk100ms>=1001) clk100ms=off;
	}
	if (clk10ms!=off) 
	{
		clk10ms++;
		if (clk10ms>=101) clk10ms=off;
	}
	// Timer clock is 1mhz, timer is 8bit.
	// Now we set the timer register to 156 so it takes 100 timer clocks to overflow.
 	// This will mean the interrupt code executes at 1mhz/100 = 10000Hz		
	TCNT0 = 156;	
}

void main(void)
{
	
	if (clk1000ms==off)
	{	
		// put code here to run every second

		clk1000ms = on;
	}	
	if (clk100ms==off)
	{
		// put code here to run 10 times a second

		clk100ms = on;
	}
	if (clk10ms==off)
	{
		// put code here to run 100 times a second

		clk10ms = on;
	}
	
}
</pre>