« previous next »
Pages: [1]   Go Down

Author Topic: 'uCurrent' circa 1976  (Read 1081 times)

0 Members and 2 Guests are viewing this topic.

Offline srruhl3701Topic starter

  • Newbie
  • Posts: 8
  • Country: us
'uCurrent' circa 1976
« on: August 13, 2020, 09:13:46 pm »
While browsing old electronics magazines, I came across a construction project of a miliamp volt meter accessory. It uses a CMOS op amp, and also can measure current with 1 nA full scale on the 1 volt range of the meter.

It is designed for analog meters with 1k Ohms/Volt or greater.

https://archive.org/details/197607PopularElectronics/page/n3/mode/2up
Logged
 

Offline SilverSolder

  • Super Contributor
  • ***
  • Posts: 6126
  • Country: 00
Re: 'uCurrent' circa 1976
« Reply #1 on: August 13, 2020, 10:03:55 pm »

I guess it would need a zeroing pot, if it is not based on a chopper amp?
Logged
 
The following users thanked this post: srruhl3701

Offline joeqsmith

  • Super Contributor
  • ***
  • Posts: 11989
  • Country: us
Re: 'uCurrent' circa 1976
« Reply #2 on: August 14, 2020, 01:30:53 am »
Are you referring to the "millivolter" that allows a volt meter to read millivolts?
Logged
 

Offline srruhl3701Topic starter

  • Newbie
  • Posts: 8
  • Country: us
Re: 'uCurrent' circa 1976
« Reply #3 on: August 14, 2020, 02:01:58 am »
Yes, it also has selectable shunts to use for reading amps.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee