Hi Everybody,
I am a newbie in electronics, and bought this Rigol MSO1074Z from a friend not too long ago.
The problem is, I seem to have managed to destroy it when I tried to hack it following the Youtube post, SDGEE #04 Unlocking Rigol MSO1074Z Options, (which was by the way done very well).
I followed the instructions in the video as follows:
1. Connecting the Olimex ARM-USB-OCD-H to the MSO1074Z JTAG header
2. Started the DOS command window
3. Powered the oscilloscope
4. Entered the command prompt to connect to the oscilloscope.
The following were the outcomes:
1. The scope immediately went blank (as shown in the attachment) and won't boot again.
2. I got a an error from the command prompt that the device was not found. This was my mistake since I forgot to install the
Olimex ARM-USB-OCD-H driver.
I will very much appreciate some help figuring how I can bring my oscilloscope back to life if at all possible.
I want to apologize in advance if this topic has been covered already, and thank you all in advance for you help.
Thanks,
m2kara...