More HP spam. 6205 initial look...
inside. yuck. Someone didn't like the exposed mains wiring (I'm not a fan of it either) but decided masking tape was appropriate. It'll be in a stack here so good.
Front. Looks ok. One knob bust as expected. 3DP job coming up. Might try ABS
Quick brush - looking better already:
So TODO List:
1. Clean it out.
2. Look for anything about to explode.
3. Undo the masking tape job
4. Check the barrier strips are wired up right on the back
5. Check capacitor ESRs and replace if required.
6. Fire up, check meters.
7. Clean up rest of case and desticker.
8. Recalibrate
9. Burn in.
10. Check cal again.
11. 3DP a new knob for it.
Happy so far.
Edit: I actually bought this one for the flexibility. It'll do 80V at 300mA, 2x 15v at 600mA, 20V @ 1.2A etc. Really useful.