« previous next »
Pages: [1]   Go Down

Author Topic: Peak Atlas wall brackets  (Read 784 times)

0 Members and 1 Guest are viewing this topic.

Offline cowasakiTopic starter

  • Frequent Contributor
  • **
  • Posts: 605
  • Country: gb
Peak Atlas wall brackets
« on: January 29, 2021, 10:15:26 am »
Just in case anyone wants to hang their Peak Atlas testers on the wall I have created 3D printable wall brackets. 

The brackets are in twos or fours but they go together so you could print 3x twos for six in a line or a two and a four for 2x3 etc

Uploaded to thinyverse for storage.

https://www.thingiverse.com/thing:4741886

Logged
 
The following users thanked this post: Fraser, Kean, Tom45, tubularnut, dl6lr, rernexy

Offline Fraser

  • Super Contributor
  • ***
  • Posts: 13267
  • Country: gb
Re: Peak Atlas wall brackets
« Reply #1 on: January 29, 2021, 04:42:30 pm »
Nice design. Thank you  :-+

Fraser
Logged
If I have helped you please consider a donation : https://gofund.me/c86b0a2c
 

Offline tautech

  • Super Contributor
  • ***
  • Posts: 29028
  • Country: nz
  • Taupaki Technologies Ltd. Siglent Distributor NZ.
    • Taupaki Technologies Ltd.
Re: Peak Atlas wall brackets
« Reply #2 on: January 29, 2021, 07:22:03 pm »
At the top of this TE board is a sticky thread you should also post about your 3dp creation:
https://www.eevblog.com/forum/testgear/replacement-knobs-feet-and-fittings-for-test-equipment/
Logged
Avid Rabid Hobbyist.
Out of office and unavailable for a few days.
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee