I work mostly with RF, and very often use inductors smaller than 1uH. When I saw this video:
where he measures short pieces of wire of 20 and 40nH (towards the end of the video), I was hooked, and immediately ordered one.
But when I got it, it won't measure such low inductances..
On the video, there is a prominent caption stating "Measurement frequency: 10kHz", however mine offers only 100Hz and 1kHz.
Could this be just the wrong version of firmware? Or has the hardware changed? The PN on the board is slightly different than that on the video and the picture on Aliexpress?