« previous next »
Pages: [1]   Go Down

Author Topic: Agilent 6611C Setting Question  (Read 644 times)

0 Members and 1 Guest are viewing this topic.

Offline sampler1Topic starter

  • Regular Contributor
  • *
  • Posts: 80
  • Country: ca
Agilent 6611C Setting Question
« on: July 14, 2021, 01:07:34 am »
Good day!
I think this might be a lame question but I can't seem to find the answer. I replaced the digital board in an Agilent 6611C as the original was blown.
It is now Functioning as a 6612C after installing the new PCB. In the menu" hold 1 and 0" the different models come up  and it is showing it is set to 6612C. I can change it to 6611C but I have no idea how to save that setting?  |O
I sure this is an easy one for the pro's.
Thanks all!
Logged
“Electronic devices are powered by white smoke. When smoke goes out, device is dead.”
 

Offline Kean

  • Supporter
  • ****
  • Posts: 2228
  • Country: au
  • Embedded systems & IT consultant
    • Kean Electronics
Re: Agilent 6611C Setting Question
« Reply #1 on: July 18, 2021, 04:56:58 am »
Normally on these models I think it is Shift and Save.
Have you tried this?  What else have you tried?
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee