Hello everyone
I have a RTO-1012, unfortunately it the boot prompt GB Receiver" (gigabit receiver) error This causes 1 channel 2 channels to not work
I try to open the oscilloscope to clean the ADC<->FPGA connector
Unfortunately The fault persists
Is there anyone to help me
oscilloscope logļ¼
-> Running signal quality check
! Error: not enough input power at Input_Ch_2, Lane#0
! Error: not enough input power at Input_Ch_2, Lane#1
! Error: not enough input power at Input_Ch_2, Lane#3
! Error: not enough input power at Input_Ch_2, Lane#5
! Error: not enough input power at Input_Ch_2, Lane#6
! Error: not enough input power at Input_Ch_2, Lane#7
! Error: not enough input power at Input_Ch_2, Lane#8
! Error: not enough input power at Input_Ch_2, Lane#9
! Error: not enough input power at Input_Ch_1, Lane#0
! Error: not enough input power at Input_Ch_1, Lane#1
VGA Gain: a low value stands for good signal quality,
possible range 0 to 16(-6.02 dB to 10.6 dB),
valid range 0 to 6(-6.02 dB to 0.205 dB).
Input_Ch_2
Lane #0: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #1: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #2: 0(-6.02 dB)
Lane #3: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #4: 0(-6.02 dB)
Lane #5: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #6: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #7: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #8: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #9: 15(9.54 dB) <<<<<<<<<<<<<<< !
Input_Ch_1
Lane #0: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #1: 15(9.54 dB) <<<<<<<<<<<<<<< !
Lane #2: 4(-1.87 dB) <<<<
Lane #3: 3(-2.91 dB) <<<
Lane #4: 4(-1.87 dB) <<<<
Lane #5: 3(-2.91 dB) <<<
Lane #6: 4(-1.87 dB) <<<<
Lane #7: 3(-2.91 dB) <<<
Lane #8: 4(-1.87 dB) <<<<
Lane #9: 5(-0.833 dB) <<<<<
Signal quality check failed!
-> Running DFE status check
Error: DFE of Input_Ch_2, Lane #2, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #3, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #4, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #5, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #6, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #7, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #8, Eye-Width too small
Error: DFE of Input_Ch_2, Lane #9, Eye-Width too small
Error: DFE of Input_Ch_1, Lane #1, Eye-Width too small
DFE status check failed!