« previous next »
Pages: [1]   Go Down

Author Topic: Probe compensation 1:1, 10:1  (Read 1246 times)

0 Members and 1 Guest are viewing this topic.

Offline Frank_MVTopic starter

  • Regular Contributor
  • *
  • Posts: 119
  • Country: de
Probe compensation 1:1, 10:1
« on: November 22, 2020, 12:51:09 pm »
General question about probe compensation.
I have switchable probes 1:1, 10:1.
If I perform the compensation for 1:1, it is no longer correct for 10:1 and vice versa.
How do I proceed now ?
Do I have to compensate again and again when switching the divider ratio ?

br,
Frank
Logged
 

Offline Miti

  • Super Contributor
  • ***
  • Posts: 1341
  • Country: ca
Re: Probe compensation 1:1, 10:1
« Reply #1 on: November 22, 2020, 02:27:52 pm »
Probe compensation is for 10:1 only, it shouldn't have any effect in 1:1 mode.
Logged
Fear does not stop death, it stops life.
 

Offline Frank_MVTopic starter

  • Regular Contributor
  • *
  • Posts: 119
  • Country: de
Re: Probe compensation 1:1, 10:1
« Reply #2 on: November 22, 2020, 03:48:31 pm »
Yes that's right, you're right. I was wrong  :-BROKE
Logged
 

Online David Hess

  • Super Contributor
  • ***
  • Posts: 16895
  • Country: us
  • DavidH
Re: Probe compensation 1:1, 10:1
« Reply #3 on: November 22, 2020, 04:28:08 pm »
That is right.  1:1 probes require no compensation so the compensation in 10:1 mode has no effect on 1:1 mode.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee