Fluke 355

[RAL97]

Hello everyone,
Hope you are doing great.
I have a Fluke 355, but the right jaw that has the flat cable is broken just 1 mm when it comes out the inner section of the clamp. Trying to fix it I did some permanent damage to it and now it cannot be fixed anymore. I contacted Fluke for a spare jaw but they didn't agree on it saying is beyond repair. So I am asking you my fellow EE enthusiast where to find this specific part.
Any help or indication is greatly appreciated.
Thank you very much for your time.
Best Regards

[BeBuLamar]

How old is the meter?

[RAL97]

to be honest i don't know. If you want I can send you the serial number.

[BeBuLamar]

Well it's an expensive meter and is warranted for 3 years. So that is the reason why I asked. If it's less than 3 years just send it to Fluke. Actually I would contact Fluke for the repair any way even if it's out of warranty.

[RAL97]

Well I contacted them and they said that Fluke doesn't repair this model, even changing a part they don't do it.
That' why I am asking and searching for a third party retailer. I also thought of using the clamp of Fluke 319, but the flat cable was very short.

[BeBuLamar]

Very strange! The 355 as well as the 353 are quite expensive and yet they are made in China. Perhaps Fluke rebrand them?? Anyone knows?

[RAL97]

To be honest I don't have any idea. I didn't even managed to find a service manual. I am writing to different companies in USA, that repair fluke in hope they can give me a solution. But because I live in Albania, I doubt they will ship me the part I need.