Hello Magnus, in short Yes! It does work:-
Hi!
I'm running VMware Fusion om my Mac and most tings work's but not my DCA75 Pro.
The Atlas software can't detect the device.
The device shows as "unknown device" in "device manager" in windows 11.
Any one got this to work?
After reading carefully the included User Guide (dca-pro-user-guide-en.pdf) and following it as closely as possible:
- thus NOT plugging in the DCA-75 Pro until after all the VirtualMachine WIndows/.Net/USB drivers/etc. had been installed
- ensuring the "Connect to Virtual Machine" when prompted by VMware Fusion after pluggin DCA-75 in
it all "just worked"
Here are a few screenshots to show the install then the application running drawing nice curves...
![](https://www.eevblog.com/forum/testgear/peak-dcs75-pro-virtual-machine-(windows)-in-vmware-fusion-on-osx/?action=dlattach;attach=1806970;image)
![](https://www.eevblog.com/forum/testgear/peak-dcs75-pro-virtual-machine-(windows)-in-vmware-fusion-on-osx/?action=dlattach;attach=1806958;image)
![](https://www.eevblog.com/forum/testgear/peak-dcs75-pro-virtual-machine-(windows)-in-vmware-fusion-on-osx/?action=dlattach;attach=1806964;image)