B&K Precision 3601

[1lulu2]

I viewed Dave's review on the B&K 3601, and it looks like a good piece of test equipment. I am sure someone has asked this question before, but I am starting to design MCU boards, etc. and I need a DC electronics load unit for prototyping, and testing, so should I buy the 3601, or build my own, or buy a cheaper, or more expensive one, etc? I was also looking at the Keithley 2380-120-60 -- more expensive unit. I am sure the lower the A and V loads, and precision, the more expensive the unit will cost!

1lulu2

[BU508A]

Have you checked out the Maynuo M9812?

http://www.ebay.de/itm/142232839855