Sorry, I don't know what you're doing. If settings are showing, you're clicking for a long time.
Mobile users: Warning, link to 2MB gif!
It's really this simpleWhen booting, there's always some error detected before the voltages and sensor readings are initialized.
Thanks for reporting the booting issue, I never had it, as I always had the resume mode in "Last".
I quickly figured out that it was the Resume option overriding the Boot mode.
Fixed the issue by adding a boot flag, set when exiting the boot screen.
If any error is cleared before the boot flag is set, force the configured boot mode. Otherwise, set the Resume mode.
I also increased the shake filter timing window: Accept changes happening between 100-500ms, instead 200-400ms
Still, it's good to ignore very slow or very fast changes, usually it's just vibration or noise.
Hotfix builds released. It's so much easier now I automated it...
It there's something confusing in the operation manual, let me know.I want to avoid the same questions being asked everytime.