Thanks guys! I really appreciate it. I lost count of the tips I've killed for the benefit of the development. Easily 12...15...
It's not like I'm wanting money for it, but it would be nice to have some support for the project, buying new tips when they burn down, or properly supporting problematic boards. I added a link in my signature!
About the burn out, it's not the developing itself. I love new challenges, I like to support this project!
What I don't like is to waste my time. If there's an issue in Quicko boards, I set up the debugger and I ususally find the problem quickly. But with others, it means hours of trial and error.
Talking about errors, they seem to be gone, so... new builds!
Can't test PID settings until I buy new tips (The handle half-melted too ...
) so meanwhile I reverted to older ones.
I made some work in the graphics driver, to allow simultaneous software and hardware i2c coexistence, and detect if the display is connected to the hardware, or use software mode instead.
It'll be specially good for the ksger 2.1, which has the display connected to normal pins, requiring software mode.
This will allow modifying them by connecting the display to the correct pins, and yet maintain compatibility with non-modded boards, without requiring any firmware modification.
This is still WIP, so not enabled by default. When/if the detection works correctly, it will be added to future builds.
Added this picture to github for modding instructions.