Hey guys,
I have auxiliary LED lights on my motorcycle, but water got inside one of them (twice) and they rusted inside. First time I cleaned them up and they worked for a while, but water got inside again and this time they are toasted. By toasted, I mean LED driver board needs to be replaced. LED attached to a heatsink works (tried it with my power supply directly at 3.7v).
Here's pictures of LED driver board:
![](https://lh3.googleusercontent.com/-4lPU27n8MnI/UnUhanyzcMI/AAAAAAAALl4/ZaFAtf_tKW4/w415-h553-no/IMG_20131102_165802.jpg)
![](https://lh5.googleusercontent.com/-BwJz60lIDu8/UnUhDOJtouI/AAAAAAAALmA/jbdI1DduT4U/w415-h553-no/IMG_20131102_165743.jpg)
Board is produced by TRIAL TECH part no. 3180-PCB, v2.3.2.
I'm almost certain that I will not find the same exact one to replace, but it is worth a shot to ask here as someone here may even work there - this is a big community
![Cheesy :D](https://www.eevblog.com/forum/Smileys/default/cheesy.gif)
If I don't find that board, I will have to get 2 new ones (for both lights) - they shouldn't be hard to find, but will need to find ones with 2 holes for screws, and that could be a problem.
Btw, this is 3 mode driver board, and both aux led lights cost over 300 eur, so I wouldn't like to throw that much money away
![Cheesy :D](https://www.eevblog.com/forum/Smileys/default/cheesy.gif)
\
Any input is appreciated!
Thanks,
Balsa