Fluke 289 "Recording Memory Available"

[Richard W.]

Hi,

i have a question for all Fluke 289 users (and maybe 287).
Could you please check the "Recording Memory Available"?     [F4] Setup -> Meter Info [F1] -> tenth line
Mine shows 99% even when i reset the meter to factory default. (This erases the whole memory.)

I assume 99% should also be ok.  ( http://www.phasorlabs.com/images/SV_Fluke_UsingTheFluke289_C.pdf )
But it looks a bit strange to me...


Richard

[Kiriakos-GR]

1% less space as "file system data storage" its not major issue.
If it goes 98% after reset, this could be an problem.

[Alex]

Mine is 100% when I erase everything, as you know Richard.
I too would be interested in knowing why this is.

[Kiriakos-GR]

Do you both have the same firmware ?

[Alex]

I have upgraded to the latest, but it was 100% out of the box too.

[Alex]

I also cannot replicate the IR port/light issue either. A calibration sticker prevents me from taking it apart to check the boards rev number.