« previous next »
Pages: [1]   Go Down

Author Topic: VC99 multimeter - adjusting  (Read 2465 times)

0 Members and 2 Guests are viewing this topic.

Offline akisTopic starter

  • Frequent Contributor
  • **
  • Posts: 981
  • Country: gb
VC99 multimeter - adjusting
« on: April 05, 2017, 10:05:50 am »
Hello

I blew a fuse on my VC99 multimeter and while trying to remove the old fuse I accidentally broke a pot on the board, it is labelled VR5. Could anyone please supply me with a schematic or manual to explain how to adjust this pot?

Many thanks
Logged
 

Offline RayRay

  • Frequent Contributor
  • **
  • Posts: 307
Re: VC99 multimeter - adjusting
« Reply #1 on: April 05, 2017, 10:35:44 am »
Could you provide a picture of the circuit board?
Which exact VC99 is it? There are quite a few different manufacturers (Vichy/Vici/Victor) and they're all built a bit differently.
Was the VR a full metal one, or did it had a piece of plastic on it? Does it have any numbers on it (or on the broken piece)?
Logged
 

Offline akisTopic starter

  • Frequent Contributor
  • **
  • Posts: 981
  • Country: gb
Re: VC99 multimeter - adjusting
« Reply #2 on: April 05, 2017, 11:01:08 am »
I have closed the multimeter now. The VR is not broken (badly) it was plastic with a metal top, I managed to put it together, and turn it left and right a few times. I just need a schematic or a "calibration" manual I suppose
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee