How to JUMPER the G-TAB 2 (GT-P5110)

[WGenius]

Hi friends 
I have a Galaxy TAB 2 10.1 (GT-P5110) which has a broken power button (Key FPCB-Power Volume ASSY - Part Number: GH59-12148A), the flex cable of that button (ASSY) was cut, anyway; my question is:
How to turn ON this TAB from the logic board, in other words: which PINs needs to be jumpered to power on the TAB, thanks in advance 
NB: I have the service manual (Schematic, PCB Diagrams ...).

[Monkeh]

Hi friends 
I have a Galaxy TAB 2 10.1 (GT-P5110) which has a broken power button (Key FPCB-Power Volume ASSY - Part Number: GH59-12148A), the flex cable of that button (ASSY) was cut, anyway; my question is:
How to turn ON this TAB from the logic board, in other words: which PINs needs to be jumpered to power on the TAB, thanks in advance 
NB: I have the service manual (Schematic, PCB Diagrams ...).

Have you considered the ones going to the power button?

[WGenius]

No, I wouldn't be asking if I did 

[Monkeh]

No, I wouldn't be asking if I did 

You have the device, you have the schematic, you have PCB diagrams.. why are you not just operating the power button?

You have all the cards here, and you're not letting anyone else see them..

[WGenius]

Well, the service manual is available online @ cpkb.org
plus, I don't fully understand the schematic  i'll post some pictures.

[WGenius]

Power & Volume Key schematic

[WGenius]

That's the power&volume button

[Monkeh]

Short pins 1 and 2 of HDC500. It may be easier to go for the appropriate pads of C517 and ZD500.

Try to get those right or you'll break things. I can't tell from those files which side of the components to go for.

[WGenius]

Short pins 1 and 2 of HDC500. It may be easier to go for the appropriate pads of C517 and ZD500.

Try to get those right or you'll break things. I can't tell from those files which side of the components to go for.

Thank you Monkeh these are the right pins (1 & 2), at first I want to try these two pins but I asked to be sure, thanks again, you're the man