« previous next »
Pages: [1]   Go Down

Author Topic: Did I brick the Hytera Radio?  (Read 569 times)

0 Members and 1 Guest are viewing this topic.

Offline Lord of nothingTopic starter

  • Super Contributor
  • ***
  • Posts: 1591
  • Country: at
Did I brick the Hytera Radio?
« on: January 12, 2021, 08:15:38 pm »
http://setronics.net/wp-content/uploads/descargables/Documentos-software/DMR/PD506/Manuales%20Tecnicos/WF_Hytera%20PD50X%20VHF&UHF1%20Service%20Manual%20R5.6%2003-17-14.pdf
Hopefully Virus Free.

Page 109 -> J4 there is a can who I pushed in when I tried to get the Front Plastik off. I dont realise there is on top something to unscrew.  ::)...
So I tried to lift that can up truth a small vent hole and what happen... The needle brake...  :clap:  :wtf: ...
So how to remove that can?  :-\ Hopefully under nothing is damaged.
Thanks
Logged
Made in Japan, destroyed in Sulz im Wienerwald.
 

Offline geggi1

  • Frequent Contributor
  • **
  • Posts: 441
Re: Did I brick the Hytera Radio?
« Reply #1 on: January 13, 2021, 09:22:39 pm »
The can is probably soldered down.
Hot air might be an option but you must be careful because the components are small.
it might also be possible to remove the can with a soldering iron.
Logged
 

Offline Lord of nothingTopic starter

  • Super Contributor
  • ***
  • Posts: 1591
  • Country: at
Re: Did I brick the Hytera Radio?
« Reply #2 on: January 13, 2021, 10:40:52 pm »
How is the can soldert? I could not see any.
Logged
Made in Japan, destroyed in Sulz im Wienerwald.
 

Offline geggi1

  • Frequent Contributor
  • **
  • Posts: 441
Re: Did I brick the Hytera Radio?
« Reply #3 on: January 16, 2021, 03:12:25 pm »
the can is usually soldered on the edge with a thin layer of solder on the edge.
Logged
 
The following users thanked this post: Lord of nothing
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee