« previous next »
Pages: [1]   Go Down

Author Topic: FLUKE 179 CALL ERR  (Read 780 times)

0 Members and 1 Guest are viewing this topic.

Offline fawadrjTopic starter

  • Newbie
  • Posts: 1
  • Country: pk
FLUKE 179 CALL ERR
« on: February 17, 2020, 09:16:09 pm »
HI , MY FLUKE BATTERY GOES LOW, I REPLACE BUT IT GIVING NOW "CALL ERR"  CHECK BATTERY V ITS OK,, IS IT POSSIBLE TO MAKE FACTORY REST,, OR ANY OTHER  TIP,,
Logged
 

Offline Ordinaryman1971

  • Frequent Contributor
  • **
  • Posts: 323
  • Country: us
Re: FLUKE 179 CALL ERR
« Reply #1 on: February 18, 2020, 07:05:06 pm »
Did you try to calibrate it?
Does the error go away if you keep the meter on, can you make any measurements when the message goes away. Is the message displayed on all ranges or only, for example, if you are in DC Volts or Ohm measurement mode?
If you get this message  you have to calibrate your meter... 
Logged
 

Offline retiredcaps

  • Super Contributor
  • ***
  • Posts: 3575
  • Country: ca
Re: FLUKE 179 CALL ERR
« Reply #2 on: February 18, 2020, 09:27:00 pm »
If you bought the meter from an authorized dealer and meet its terms and conditions, return it to Fluke for repair.

The terms and conditions are on page 2 or your manual.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee