« previous next »
Pages: [1]   Go Down

Author Topic: DIY CM Chokes for Low Z VNA Measurements  (Read 133 times)

0 Members and 1 Guest are viewing this topic.

Offline mawyattTopic starter

  • Super Contributor
  • ***
  • Posts: 3625
  • Country: us
DIY CM Chokes for Low Z VNA Measurements
« on: July 17, 2024, 11:49:22 pm »
Curious about DIY CM Chokes for use with for very low Z (<0.1 ohm) ShuntSeries-Thur VNA Measurements in the moderate frequency range from ~100KHz to ~10 MHz. Plenty of discussions here about the Measurements but little detail and images of the CM chokes utilized.

https://www.eevblog.com/forum/rf-microwave/impedance-measurement-with-vna-using-series-shuntseries-through-methods/150/

Requesting details on these DIY CM Chokes to be able to construct such.

Thanks in advance.

Best,
« Last Edit: July 18, 2024, 01:28:59 am by mawyatt »
Logged
Curiosity killed the cat, also depleted my wallet!
~Wyatt Labs by Mike~
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee