« previous next »
Pages: Prev 1 [2]  All   Go Down

Author Topic: Questions about diy pcb UV solder mask - "mechanic" brand. U  (Read 36945 times)

0 Members and 1 Guest are viewing this topic.

Offline coppercone2

  • Super Contributor
  • ***
  • Posts: 10739
  • Country: us
  • $
Re: Questions about diy pcb UV solder mask - "mechanic" brand. U
« Reply #25 on: January 03, 2021, 02:48:00 pm »
yea I think you will in general experience a pain in the ass removing epoxy from anything

i think it will foul your surface grinder stone
Logged
 

Offline Brentd27

  • Newbie
  • Posts: 6
  • Country: us
Re: Questions about diy pcb UV solder mask - "mechanic" brand. U
« Reply #26 on: January 14, 2022, 08:27:19 pm »
I know this is an old thread, but I was wondering if using FEP film, as used in 3D resin printers, for the solder mask film might work.  Don't know if toner will stick to it though.
Logged
 

Offline coppercone2

  • Super Contributor
  • ***
  • Posts: 10739
  • Country: us
  • $
Re: Questions about diy pcb UV solder mask - "mechanic" brand. U
« Reply #27 on: January 14, 2022, 11:22:34 pm »
freezing it before working might help, this might be application of cryogrinding, in reference to grinding epoxy
Logged
 
Pages: Prev 1 [2]  All   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee