Thermistor HELP

[lucasromeiro]

Hello guys.

I'm using an efr32bg22 Bluetooth module and would like to read a thermistor with it!

I've never used a thermistor.

Reading a little about the subject, it seems a little complicated to me.
There are some formulas for obtaining a conversion but apparently the best way is to use a conversion table.

Unfortunately I don't know how to do any of them.

I would like to use the table or a method that helps to have greater precision.

I bought 2 thermistor models and I have them here with me:
NTCSP103JF103FT1S
TX06F103F3435ER

I had a temperature sensor that used a thermistor to measure the temperature inside a refrigerator. I want to do the same thing.

I disassembled the sensor and the circuit I found was as follows:


I imagine that I can replicate this circuit, but the part of converting the ADC signal to the temperature accurately I still don't know how to do it.

Can someone help me?

Important: I intend to use the range from 30 to -40 degrees celcius.
Most of the time it will operate in the range of 10 to -20 degrees celcius (inside a fridge or freezer).

Can anyone help me with this?