I've been working on a project to build an in vivo temperature acquisition system for biomed research. I recently got ahold of some LT2983s to provide an all-in-one solution. Unfortunately, I can't seem to get the thing to work with a standard arduino. The "Going Generic" article doesn't seem to apply to this particular chip.
Here's the referenced article:
http://www.linear.com/solutions/4537I've dug through the corresponding .h and .cpp files, but despite a few attempts, can't get it to work on either Arduino Uno or Nano (both fakes but worked with LT1867). Of note, when I upload the any of the demo .ino, I get "2983" in the serial monitor indicating the SPI bus was initiated, but nothing further. When I disconnect the SPI-MISO line, I get line after line of output dialog showing errors, which originates from the Arduino, not the 2983.
Need a bit of spoon-feeding on this one as this is my first foray into SPI. Thanks in advance. Happy to answer any additional questions or provide images etc.