I've gave my Weller WD1 + WSP80 iron, in exchange to this Data Precision 8200.
Nice trade. i always wondered how those newer Wellers are.
I've the same setup with an additional iron (WMP) and WDH20T stand (connects to the WD1 to fully utilize the setback features; works with both irons).
Performance on both irons is excellent IME (good thermal recovery). For example, I can solder at 500F without being on the joint too long (assuming I'm not soldering over a ground plane).
And as you're in the US, you should give the Hakko FX-951
serious consideration (it uses cartridge tips, but they're not expensive; ~$11 for common profiles/shapes). Simply put, it's an amazing value as well as an excellent performer. Another benefit is the thickness of the plating on Hakko's tips is such that tips will last for a decade with simple care (keep it clean & tinned).
Between the two, I'd go for the Hakko. Unfortunately, it wasn't out yet when I bought what I'm currently using.
Another brand to consider would be Ersa if you're after a really good station that doesn't use cartridge tips (their tips are also very well made).
FWIW, I mention the tip thickness as Weller has had some QC issues with the LT series & ET series tips that are made in Bosnia or Mexico respectively. A quick check of the good vs. bad tips I've gotten, it's ~33% (i.e. the plating sloughs off or is cracked).
![WTF? :wtf:](https://www.eevblog.com/forum/Smileys/default/wtf2.gif)
Their tips made in the US, Germany, or Japan don't have these issues.