Hi Fraser, i increased the Spiral height to 0.9mm (so 3 layers at 0.3mm layer height) for you.
I did not test it, so be careful...
I tried it once, with the Spiral at the same height as the Chopperwheel frame (3mm)
but it was completely out of balance...
I have attached the .stl file.
Bill, I think my camera is fine, i use it without the Argus3 control board.
So no Iris control (Iris is fully open), and i have set contrast and brightness to Auto in the GUI.
But i just measured the current, it draws around 550mA at 8V and after a few seconds it drops to around 350mA.
And yes i wanted to highlight the "sun-safe feature", i would never do that with a Vox or A-Si or an old Pevicon camera.
I have also noticed, that the argus3 camera can see the sun through glass. But my A-Si and Vox cameras cant, i thought BST is only LWIR?
here is a video:
https://youtu.be/hV0hQQB1D9QThis might be slightly off topic, but i have a question regarding the Raytheon BST GUI.
I decompiled it, and it looks like there is another password.
It accepts "user" and "tech", but i cant see any difference.
There is a Menu in the GUI, which looks like it might allow me to mark bad pixels.
I see it with the decompiler, but there seems to be no way to get to it...
Maybe someone has an idea? I have a PalmIR250 with 12 bad pixels...
i have attached pictures of the menus, i cant access...