It's hw version 58, so IF it came with one version lower of firmware, I would have already hacked it and gone to 00.02.04.01. Hw version 58 is fine with 00.02.04.01.00, but no luck because no hack has been found for firmware 00.02.05.02.00, so as of right now I'm still waiting for one.
Something a little off topic, I was double checking something a second ago and I did something kind of stupid. At the DS1052E system info screen, I did the ch1/ch1/ch2/ch2/math sequence to check on the hardware version number, then backed out. Then later, I wanted to double check something else and I went back to the system info screen and did the ch1/ch1/ch2/ch2/math sequence again without realizing that it was already in the "extended" mode! I know I've been warned about pressing ANYTHING other than Run/Stop while in that mode, and I wasn't paying attention and messed up badly.
The scope seemed to be working fine, I recalibrated it just for good measure, and it seems totally okay. The probe calibration square wave seems normal, and at the correct 3.0V, so did I screw something up?
Edit: Disregard that, it turns out messing up the scope while in the extended info screen is only possible if you have an older firmware, it's a bug that they fixed in later firmwares.