Thanks a lot, Sicco
I use normally 3.3V TTL . This is the setting I put on my TTL to usb adapter (foca v2.2)
https://wiki.iteadstudio.com/FocaI have now verified that the data I type is properly received by the TDS by looking to the debug zone
If I type : *IDN?
I see in the 30 last car
*IDN?\015
so this is correct as I configured with CR (\015)
ON the opposite, No communication Module is detected, but reading the past posts from pmercier
Little update. Received the connnectors today. They're a perfect match.
I soldered dupond wires for the 3.3v serial/usb module directly on the provided pins and ... worked like a charm once i removed the hardware control flow from the scope config.
Sended : *IDN?
Got : TEKTRONIX,TDS 3032C,0,CF:91.1CT FV:v4.05 TDS3FFT:v1.00 TDS3TRG:v1.00
I understand that the 100 pins connectors + TTL to USB was sufficient.