Hi everyone,
I am new to the group and I was pointed to this thread because I recently purchased a Hantek DSO2D10, which is their 2 channel 100Mhz Oscilloscope, which I am returning. I have found this unit extremely buggy and while I thought it would be a great scope for what I need it for, the bugs have become way to intrusive.
For example, if you change settings too fast, then the unit will completely lock up, and will act as though it's bricked. To fix this you have to reflash the firmware. Being that I tend to move quickly I wind up hitting this bug every few minutes, have to stop what I am doing, reflash the firmware and start over.
The other bug which has me really perplexed is its inability to accurately display proper voltage when you are trying to measure under 1V or is it 1mV, honestly, I can't recall, but I learned about this from a youtube who did a comparison between this unit and the equivalent Firsi and OWON, and sadly the OWON beat it out as far as accuracy, Needless to say, I am returning it.
Interestingly, I also have a Hantek 2D72 which is a 2 channel Scope, DMM, and Signal Generator, and I have not run into any similar bugs, I would be using this as my primary shop scope, but I have found the screen to be just too small for me. Thankfully, Amazon offered me a full refund on it, and advised me not to return it, so I decided to keep it and this way I have a spare scope to use during this time where I now have no desktop scope until I purchase a new one, however, which one to replace the DSO2D10 with, is something still under discussion in another thread where everyone is being extremely helpful.
Anyway, I thought you all might find this post useful since this discussion is about the Hantek 2Dxx models. and I thought I should share my experience which honestly has not been the best. Hope this helps.
Cheers,
Systops