It's a Win11 pro, but I'm pretty sure I'm doing something wrong, or it's not working fully..as the only thing I'm able to be more or less initialize it, and then I can turn on the load and turn off the load with the PC sw. by clicking down at the left bottom corner (with these 3 bars.. PC, Remote, CH1 on/off.) and jump between the different modes.
I don't seem to be able to put any values onto the device..if I hit that numerical numbers and hit enter or turn that dial.. it simply does not resonate with the device, even though they clearly are connected but could be something as simple as a setting I'm lacking.
I plugged in a USB3 cable. and choose the same 115200 baud as I recall were present from scratch on the unit.
Could be something fundamental / obvious, I am missing as a novice - or perhaps it's down to win11pro or I need to run it in some combability-mode or maybe there is a basic feature I haven't activated on the unit-
I just installed the LOAD.rar, which installed a bunch of scary NI-VISA stuff. No NI stuff on my Windows10 PC before this. I'm able to immediately update ET5410 current setting by either the (eccentric) knob or the 10 digit entry. Setting updates after "enter" with 10digit and immediately with knob. I havent found any effect of the lower left switches Local/Remote/PC, except that some combos don't allow usage of ET5410 controls.
FYI, link to Video of ET5410 and PC screens while changing current settings in CC mode...(hopefully link works, how are you embedding mp4 files in your post?)
https://drive.google.com/file/d/1--QffWxmANQ0icvfqkUkX05nT-Jefmet/view?usp=sharingSo at this point for me with vendor's "LOAD" software: 1. control of ET5410 from PC is working, 2. rudimentary feedback from ET5410 so LOAD software showing Volts and Amps on the main window, 3. NOTHING working on the "Figure" window, which includes datalogging, exporting, plotting.