I tried to connect to my LeCory 9354AM via RS232 with LeCroy's Scope Explorer. The 'scope has the RS232 hardware option installed. I tried using the pin header on my mainboard and a USB adapter. Both the Scope and my RS232 adapters are set up tu 19200 baud rate, 8 data bits, no parity, one stop bit. I'm using Scope Explorer 2.25.0.0 on Windows 10 64-bit (latest version).
Neither the automatic detection nor manually adding the scope work. When I add it manually the status reads "Dead".
I found some people here who successfully use Scope Explorer but unfortunately no information about what the problem might be in my case.
Is there anything I'm overlooking?