PS, what's a typical timeframe for the Self Survey to complete upon first startup?
The site survey should complete in about 24 hours. No provisions to change the interval.
On my Star 4+ it seems to complete the site survey in less than 24 hours - maybe closer to 6-12 hours? I haven't kept very good track of the time but it's been started and then restarted two more times in the first day and it's completed the survey twice, and is now on it's third startup survey. I realize it could be somewhat warm from prior starts but even the very first survey completed in well less than a day. Not sure why.
Lots of other questions developing.....
(I've read and searched the LH manual but so far haven't found the answers.)
1. Is there a way to display the Star 4+ 10 MHz signal in LH?
2. Doppler looks ver (completely) flat – is this normal? (Kinda expected to see some variation over time.)
3. What does holdover perf POOR mean? (What causes POOR? How can it be improved?)
4. Dly is -77ns, that’s a default set in the unit by the seller for the supplied antenna cable length, or something else?
5. Discipline mode is Normal - is that good or is there something better than Normal?
6. When the survey completes the plots for lat, long, and altitude in the ADEV graph disappear; the values remain displayed above the graph area but the plots disappear; GV toggles the values on and off above the graph area but not the graph plots. Kind of strange.
7. When the survey completes DAMP shows 0.000, GAIN shows -3.500 Hz/V, INIT shows 0.000 V; they are all grayed out.... good/not so good?
8. When the survey completes TC says 200.0 sec - is that good/bad/something that needs adjustment?
Thanks for any info/tips.