When the power first comes up, what is the text that appears in the RS232 right at the beginning?
It might look something like this..
:40:45 $GNTXT,01,01,02,u-blox AG -
www.u-blox.com*4E
19:40:45 $GNTXT,01,01,02,HW UBX-M80xx 00080000 *43
19:40:45 $GNTXT,01,01,02,ROM CORE 2.01 (75331) Oct 29 2013 13:28:17*4A
19:40:45 $GNTXT,01,01,02,PROTVER 15.00*01
19:40:45 $GNTXT,01,01,02,GNSS OTP: GPS GLO, SEL: GPS GLO*67
19:40:45 $GNTXT,01,01,02,ANTSUPERV=AC SD PDoS SR*3E
19:40:45 $GNTXT,01,01,02,ANTSTATUS=DONTKNOW*2D
19:40:45 $GNTXT,01,01,02,LLC FFFFFFFF-FFFFFFED-FFFFFFFF-FFFFFFFF-FFFFFF69*3E
19:40:45 $GNTXT,01,01,02,RF0 dev ok*04
Note that that particular output is from a questionable "M8N" board that I bought on ebay. A genuine M8N would have both ROM and flash firmware revisions displayed, not just one. My board appears to lack the EEPROM it is supposed to have.
Also, it may have an OXO, not a TCXO.. Which is another move to save a few pennies.. Its understandable, as I paid around $20 for my module, very little.
But I dont use it. If I was going to do it over I likely would just buy the factory fresh ones from places like cgshop which are sure to be genuine. But, the one I would need to buy for what I would want to do, the M8T, would cost ~$65-70. And I would need two of them.
Hello.
No. I wrote U-Center can display the NMEA data. The U-blox neo 7m could not be controlled at the moment.
Another problem I have noticed yet.
On my two notebooks (with docking station) The GPSDO is misinterpreted as any pointing device.
The cursor jumps over the display and menus are activated indiscriminately.
Currently, the set up only works on my old Core2Duo tower.
Jörg