Hi,
I came across this thread, when searching for same problem. The power indicator is dead, no light.
I've measured all the parts, as mentioned in this thread as follows:
I don't know:
Q9101 - no short between S and D
Seems broken:
R9101 - 9,13kR instead of 0,27R
R9109 - 12MR instead of 10R
C9126 - split in half
Seems fine:
R9104 - 36KR (probably fine, since there are two in series), same for R9106, R9105, R9107
R9110 - 46,7R (should be 47 - ok)
R9113 - 0,998KR (should be 1K - ok)
R9111 - 10KR
Didn't measure:
U9101 since I don't have a scope. Don't know D9105, D9106 - Do I need to desolder them?
Do you think it is enough to swap what I am pretty sure is broken - R9101, R9109, C9126?
Do i need to swap Q9101 even though there doesn't seem to be short between S and D? Do I need to swap U9101?
Is there anything else I should measure to identify the issue?
Are there any alternatives for TK6A65D and PF6005AS? There is no carrier for PF6005AS (except one, selling for 17€) and TK6A65D are pretty difficult to find too.
I'm trying my best to diagnose before ordering anyting, parts are not very accessible here, and I have to order everything from internet.