Motor control board W10374126
Mine is in a Maytag, but also used in Whirlpool
After the second replacement, this time I decided to record values of components on the new board before installation and repair my old one as back up.
The main chip that often blows is Power Integrations LNK304GN. I replaced with LNK304GN-TL. Digikey 596-1022-1-ND
The three sense resistors that often blow are 0.05Ohms size 5025. I replaced with Isabellenhuette VMP-R050-1.0-U Digikey 4423-VMP-R050-1.0-UCT-ND
The little resistor next to the switch is a size 3216 labeled 1R00 which is 1Ohm. I used Vishay CRCW12061R00FKEAHP Digikey 541-1.00UCT-ND
My ceramic capacitor next to the switch was also damaged. On my new one I used and LCR meter to measure it to be 0.1uF. Its a size 2012. I replaced with Kyocera KGM21AR72A104KU, Digikey 478-KGM21AR72A104KUCT-ND
For my burned traces I replaced with some thin copper wire
Note that I bought a repair kit off ebay which was supposed to have all the right components, but the sense resistors were wrong, and it was missing the small 1Ohm resistor next to the switch.