I did not know how to phrase the subject so I will try and explain here.
While I was shopping for some speakers, a few years ago, I liked and bought a pair of KEF C-80s which are 4 ohm.
The salesman asked me about my amp and also told me about another customer who had an expensive amp that was blown out by the same speakers because of the increased current draw.
So, as I look around for a DIY kit amp, what will I need to do to it, so as to not light it on fire with my 4 ohm speakers ?
I have seen some amp kits that have a switch selectable impedance on the rear panel.
Some say 4-8 whereas others say 6-8. I think that I would like my amp to be able to handle 4-8 ohm but do not know what the circuit design would look like.
Is there any hope for me or should I get new speakers .😂😂
Thanks