solder fan diagram
I'm not sure what that is
If you want to run the fan then...
- Check your 12V 100mA power pack to make sure it's DC.
- Read the writing on your 12V fan and check the current needed is less than 0.1A (100mA). If the fan only has a wattage then divide the wattage by 12 to get its required current)
- Connect the positive wire on the powerpack to the red (positive) fan wire.
- Connect the negative wire on the powerpack to the black (negative) fan wire.
The negative/positive wires on the power pack may not be marked so you might need a multimeter.