TestingI connected the LAN port on the oscilloscope to the Ethernet port on my PC with a cross-over cable. This an Ethernet cable with two of the pairs crossed.
If you need details on how to make a crossover cable check:
http://www.cablesplususa.com/rj45-utp-guide.phpIn this set up there is no DCHP, so you have to configure the LAN address manually.
You do this by going to the utility -> I/O -> LAN Settings.
I had to take the Config off Automatic and enter the IP and Subnet mask manually.
![](https://www.eevblog.com/forum/projects/lan-adapter-for-the-agilent-keysight-dso-x-3000-2000/?action=dlattach;attach=144316;image)
Note: The IP address that worked for me, may not work for you. You have to check how your Ethernet adapter in your pc is setup.
Web Browser ApplicationThere is a web server in the scope. You can access this by entering the IP address on your browser. I had to install Java on my pc. You get security warning etc.
Here are some screen shots:
![](https://www.eevblog.com/forum/projects/lan-adapter-for-the-agilent-keysight-dso-x-3000-2000/?action=dlattach;attach=144320;image)
This first picture shows the Oscilloscope controls on the PC screen. You can operated the scope by remote control.
![](https://www.eevblog.com/forum/projects/lan-adapter-for-the-agilent-keysight-dso-x-3000-2000/?action=dlattach;attach=144322;image)
This shows the
About Oscilloscope screen showing I have the Wavegen installed.
![](https://www.eevblog.com/forum/projects/lan-adapter-for-the-agilent-keysight-dso-x-3000-2000/?action=dlattach;attach=144324;image)
This shows the browser interface.
IssuesI have not found a way to set the manual IP address so that it is non-volatile. I have to re-enter the IP and subnet masks every time I start up the oscilloscope
![Broken! :-BROKE](https://www.eevblog.com/forum/Smileys/default/smiliey_scope_broke.gif)
. I looked at the teardown video. I don't see an EEPROM, so may be that is the way it was designed. Agilent may have assumed that you have DHCP on the network.
![Confused :-//](https://www.eevblog.com/forum/Smileys/default/confused0024.gif.pagespeed.ce.5xOqKkq0Co.gif)
My computer Ethernet port does not like to connect to the scope automatically. I have to disable the interface and the enable to connect the scope.
Any ideas?
Modification I need to add some mechanical support to the board to take the stress off the edge connector. I will make a small front panel and attach it with brackets to the board,
Regards,
Jay_Diddy_B