Some basic questions on Eagle CAD (I am dyslexic to the max) -
1) When I am looking at board I am always looking as if
I am suspended above the top layer of the board. Such that
if I look only at bottom layer its as if I had xray vision
looking thru top, and glass/core, to bottom ?
2) When I place a pad on top layer that is replicated on
bottom layer ?
3) If I do a single sided board, I should route and fill on
bottom layer, which is solder side ?
4) I have a cnc, is there anyway to do a "stick on" silkscreen
for labeling ?
Regards, Dana.