No, I checked on the 1.02 and 1.1.1, same behavior.
either my PSU was faulty already and I did't noticed or something happened during the re-assembly.
The calibration wizard is working, apologies, that was a midnight blunder I made. The issue is actually as below:
psu goes to standby while switch on the channel outputs (both), when OCP is enabled and output voltage from 5v and above with current below 9mA setting-no load.
when OCP disabled works upto 39.99, at 40V goes to standby.
CH1 U_DAC = 17471
06/19/2018 3:11:56 PM
CH2 U_DAC = 17263
CH1 U_MON = 8675
CH2 U_MON = 8615
CH1 U_MON_DAC = 8672
CH2 U_MON_DAC = 8600
CH1 I_DAC = 2524
CH2 I_DAC = 2495
CH1 I_MON = 742
CH2 I_MON = 704
CH1 I_MON_DAC = 1292
CH2 I_MON_DAC = 1273
AUX TEMP = 403
CH1 TEMP = 461
CH2 TEMP = 447
MAIN_LOOP_DURATION = 287 1092 2188 / 287 1090 2218 / 30 10107278
ADC_COUNTER = 926 / 9210 / 240243
Dynamic ram used: 684
Program static ram used 33908
Stack ram used 4360
My guess at free mem: 59352
SD volume is FAT 32
SD card begin result: 1
SD fs begin result: 1
SD blocks per cluster: 64
SD cluster count: 243584
SD fat start block: 12576
SD fat count: 2
SD blocks per fat: 1904
SD root dir start: 2
SD data start block: 16384
SD card size: 7990 MB
SD flash erase size: 128 blocks
SD erase single block