I know this has been asked a million times, I read many things, but I still would like your advice on a connector selection.
I want a connector to connect a load cell to a PCB. I need
- 5 circuit (4 + cable shield actually)
- good signal integrity as I am measuring uV
- easy to mate/unmate without tools
- full smt
- audible click on assembly
- right angled
- 1.5-2.5mm pitch
- ambient temperature and no vibration, so no requirements on this side
So far I have found:
- molex nano fit
- molex micro lock
- molex micro one
- molex clik
- hirose DF3EA
But I don't know which to choose.