Another update, I've been riding the crap out of bike, and the ignition seems fine (not one backfire on shutdown) I've gotten the bike up to 70, (mph) which is fast for a piston port ts185. (Sorry, no fancy dyno tests
![Grin ;D](https://www.eevblog.com/forum/Smileys/default/xgrin.gif.pagespeed.ic.QVVz6XIT20.png)
) The case I had printed turned out to be a dud (it was way too big) but maybe someone can work from the file I posted. Basically, my bike is doing fine, and because of that I have lost steam on completing a "full" cdi unit, but I feel as though the job is done, and this thread will be here for anyone who needs to build one. (And I will be here to make sure the files stay uploaded)
If anyone wants to link to this post on other (bike) forums, be my guest. I may go back and redesign the circuit board to be smaller, (this was the reason the case was so big) but the layout of the board is not important, and anyone who uses kicad could probably do a better job than I did. Anyways, If anyone wants to make the board smaller, make a good case, and wire and pot these, then they could probably sell them, otherwise I'll be here to help anyone that doesn't want to pay so much for cdi unit that could be up 47 years old!