Hi, I've gained a large quantity of PCB's from scrapped dehumidifiers which have an EastSoft ES8P5066 processor on board, this is a 32pin TPFP and searching for information on it only turns up that it's an ARM Cortex M0.
These PCB's are nothing special and would otherwise just go to be recycled but they have a complete mains power supply on board (12V, with a 5V linear reg), including JST headers for inputs, outputs, most still have the humidity and temperature sensor connected to Analogue inputs on the chip, there's a switched mains output for the compressor and 4x outputs connected to a ULN2003 and a display connector which is probably SPI so the boards could actually be really useful for prototyping or just building little 1-off projects that are self contained.
So the question is, would it be possible to program this IC under the Arduino environment? I know it won't be directly compatible, as in the device and all its I/O, functionality, timers etc etc would have to be imported. But is it possible?
Thanks.