« previous next »
Pages: [1]   Go Down

Author Topic: Where to put the flipper?  (Read 385 times)

0 Members and 1 Guest are viewing this topic.

Online loki42Topic starter

  • Frequent Contributor
  • **
  • Posts: 326
  • Country: au
Where to put the flipper?
« on: July 19, 2023, 01:25:16 pm »
I'm the proud owner of a board flipper that I got for free... I am however not the proud owner of any idea where to put it in the line or really what to do with it.  I got it thinking it for be useful as a conveyor anyway with flipping off but... if you're doing dual side boards where do you put it?  After oven before unloader?  Or before printer after destacker / start of line loader? I'm not sure how else they are used...
Logged
 

Offline SMTech

  • Frequent Contributor
  • **
  • Posts: 856
  • Country: gb
Re: Where to put the flipper?
« Reply #1 on: July 19, 2023, 03:49:14 pm »
If it were me ... before the unloader but after Reflow/AOI. But this all depends on your line setup, and workflow, the end makes more sense to me than the beginning tho'
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee