We run the machine for about 5 hours non-stop today, finishing 31 panel (124 board). Still some pick failed happen but better than my other machine, really!
Here is the video, taken from several angle - watch something at the end of the video
![Wink ;)](https://www.eevblog.com/forum/Smileys/default/xwink.gif.pagespeed.ic.cldandycH0.png)
.
https://youtu.be/pBTZm1Lf3WMCongratulations Ichan !!!
I'm so happy for you, and it's great to know you've developed a method that will allow you to proceed to production now.
Looking forward to the next stage where you produce the first batch.
Is the N4 connected to your reflow oven now?
Your mentioned installing Excel onto the machine. Is your intention to try and interface it with the application somehow?
Also, did you get a response from NeoDen about multiple heads loading from the same feeder?
Thank you. Yes the pcb goes to the conveyor oven on the first floor, before that some manual placement done plus visual inspection and correction.
I am not very serious about the Excel, just quite annoyed that i have to go back and forth to another pc.
I do not have many conversation with Neoden so far, besides i know they follow this thread closely - let they decide themselves want to win the competition or not.
In general i am fairly happy with the machine, not in big amount but for me i win the bet - it will be a jackpot if later i can use the feeders on the other machine.
Jackpot? I bought also N4 extra feeders 8x8mm + 4x12mm + 4x16mm, the cost of similar feeders for the LS60V will be enough to buy N4 machine with full feeders! (using their 2010 price when i bought the machine).
-ichan