Added in some delay and it works LCD is on
parameter TX_TABLE_len = 14, // Number of entries in table.
parameter bit [16:0] TX_TABLE_data [0:TX_TABLE_len-1] = '{
// PRI 7" LCD init
17'h1_0101, // 1 Set rst_out high.
17'h1_0100, // 2 Set rst_out low.
17'h1_008A, // 3 I2C address 0x45
17'h0_8000, // 4 Reg 0x80 = 0x00
17'h1_0201, // 5 delay
17'h0_8500, // 6 Reg 0x85 = 0x00 Power 01 = on 00 = off
17'h1_0220, // 7 delay
17'h0_8501, // 8 Reg 0x85 = 0x01 Power 01 = on 00 = off
17'h1_0220, // 9 delay
17'h0_8108, // 10 Reg 0x81 = 0x08 Orientation 0x08 = landscape 0x04 = portrait
17'h1_0201, // 11 delay
17'h0_8600, // 12 Reg 0x86 = 0x00 Backlight 0 = 0% FF = 100%
17'h1_0201, // 13 delay
17'h0_86ff // 14 Reg 0x86 = 0xFF Backlight 0 = 0% FF = 100%
} // Contents of table.