I need a 10 mV AC supply for an amplifier circuit
My function generator only goes down to 100mV pp.
I figure I would use resistors as a voltage divider or a variable pot.
Well, the bigger problem is my Agilent 54645D Mixed-Signal Oscilloscope is not reading a sine wave at that low of an amplitude.
Any ideas of what I could be doing wrong?
I've only had 2 resistors or the variable pot hooked up to the FG.
And the oscilloscope hooked up at the same ground and divider junction.
Forgot to add.....1Khz
Pot is 5K ohm