I have defined a voltage controlled variable impedance and would like to use the control voltage in order to change the resistances and see the output for all the different values. From whatever reason it will only show me one in TRAN. Any suggestions?
Vscr 1 0 PULSE (0 1 0.5m 1u 1u 0.5m 1)
Vcontrol 4 0 DC 1
L 1 2 10m
C 2 3 1u
Rref 5 0 50
X 4 0 5 3 0 ZX <-- ctrl+ / ctrl- / Rref / out+ / out-
.LIB C:\CIR\CADLAB.LIB
.TRAN 0.1m 4m 0 10u
.DC Vcontrol LIST 0.5 1 1.5 2
.PROBE
.END
So this is basically Vscr going into L - C and R(Vcontrol)