Hello,
I have some troubles with update. My ATTEN 1102CAL oscilloscope died after I updated it by mistake to waveace 100 (I put wrong file to USB stick)In fact, Oscilloscope stars OK, but there is something like noise on both inputs (looks like the data are taken in the wrong address) -–> the inputs does not works
-When I update back to sieglent1000 (this works in the past!), nothing change – still noise
-when I update back to atten (1102CAL) – scope says “product type does not match” – so impossible to return back to atten
It looks like the LecRoy change some register that are not affected by other firmwares – AD address, or product type (??)
-I add the memory chip on the board with hope that scope starts working – still noise
-when run self-calibration, it take ~10minuts
Otherwise, scope works well
Somebody have an idea?
Somebody have atten 1102CML or CL firmware (not sieglent – this does not work)
Thanks
Vrat