Glad you got it taken care of. Just curious, are you trying to duplicate the connector on the OLED? Or are you trying to make a PCB that has the correct mating connector for the OLED to plug into? I assume the latter. Is that right? If so, your CAD drawings are for the male connector attached to the OLED, and you really should be making a footprint that matches the mating connector that the OLED assembly plugs into.
Also, as Rufus mentioned, there are two sets of pads on your footprint; one set on the top layer, and one set on the bottom layer. Are you intending to use both? If not, you may wish to delete the unwanted bottom layer pads. I still don't know what your goal here is, so I'm just notifying you of any potential issue. I'm unclear on what you are trying to accomplish.